Features Simple professional hair color results

Directions

Step 1: Choose your Color

Step 2: Choose your Developer

10 Vol. Deposits tone on tone or darker.
20 Vol. Deposits tone on tone. Lifts up to two levels of natural color.
30 Vol. Lifts up to three levels of natural color.
40 Vol. Lifts up to four levels of natural color.
Tip: Add Cream Lightener to 40 Vol. to lift up to five levels of natural color.

Step 3: Apply Color

Preliminary Patch Test Procedure:
As with any hair coloring product a patch test must be conducted prior to using Satin Cream Hair Color, to ensure no allergic reaction will occur. Gently cleanse a small area on the inner surface of your forearm or behind you ear with soap and water. Apply a small amount of the preparation . After 24 hours, the treated area should be washed again with soap and water. If no irritation is apparent, you can proceed with the application of color. The test should always be carried out before each application. Satin Cream Hair Color must not be used for dyeing eyelashes or eyebrows.

Preliminary Test Strand Procedure:
Always take a strand test before giving color application to preview final results. Prepare a test solution of the exact shade and developer mixture to be used. Cut 20-30 strands of your hair and saturate the strands of hair with test solution. Check color after 25 minutes and every 5 minutes thereafter until desired color is achieved. Note timing and use for full application.

First Time Application:
Mix 1 oz. Satin Cream Hair Color with 2 oz. Satin Developer in a small nonmetallic bowl. With dry or towel dried hair, section off hair into four equal quadrants. Begin application where hair is darkest, (usually nape of neck) then apply color to the rest of hair, leaving approximately 1/2 inch of the roots untouched. Leave on hair for 20 minutes, now prepare to color the roots. Mix a fresh formula of 1 oz. color with 2 oz. Satin Developer, apply mixture to roots and process for an additional 20 minutes. Rinse thoroughly with lukewarm water. Shampoo with Satin Shampoo until the water runs clear; then use Satin Color Care Conditioner to remove all chemicals from hair and ensure optimum color longevity.

Retouch Application:
Mix 1 oz. Satin Cream Hair Color with 2 oz. Satin Developer in a small nonmetallic bowl . With dry or towel dried hair, apply mixture to the re-growth and leave on for 30 minutes. At 30 minutes, comb remaining color mixture through the rest of the hair and leave on for an additional 15 minutes. Rinse thoroughly with lukewarm water. Shampoo with Satin Color Care Shampoo until the water runs clear; then use Satin Color Care Conditioner to remove all chemicals from hair and ensure optimum color longevity.

For Gray Coverage:
Make sure to leave the color on the re-growth area for a full 45 minutes for optimum gray coverage. Do not leave Satin Cream Hair Color on the hair longer than 45 minutes, even in difficult cases. Do not leave on processed ends for more than 5 min. Do not use Satin Cream Hair Color on hair that has been previously processed with metallic dyes.